Table of Contents
Advertisement
USE
AND
CASE CLEANING
Case is designed to facilitate cleaning.
mechanical or electrical controls in the product area to
hamper routine cleaning.
drawn drain trough that angles toward the front and center
of case where the 2" waste outlet is located for easy
access.
POSITIVE DRAIN OFF
CLEANING PROCEDURES
• A periodic cleaning schedule should be established to maintain proper sanitation, insure maximum operating efficiency, and
avoid the corrosive action of food fluids on metal parts that are left on for long periods of time. We recommend cleaning once
a week.
• To avoid shock hazard, be sure all electrical power is turned off before cleaning. In some installations, more than one
disconnect switch may have to be turned off to completely de-energize the case.
• Check waste outlet to insure it is not clogged before starting the cleaning process and avoid introducing water faster than the
case drain can carry it away.
• Avoid spraying cleaning solutions directly on fans or electrical connections.
• Provide a temporary separator between those cases which are being cleaned and those which are not.
• Allow cases to be turned off long enough to clean any frost or ice from coil and flue areas.
• Remove and clean discharge honeycomb. You may need to use spray detergent and a soft, long bristle brush.
• Use mild detergent and warm water. When necessary, water and baking soda solution will help remove case odors. Avoid
abrasive scouring powders or pads.
• Remove front panels and clean underneath the case with a broom and a long handled mop. Instructions for removing the
front panels can be found on page 6 of this manual.
• Use warm water and a disinfecting cleaning solution when cleaning underneath the cases.
• When cleaning antifog doors please refer to Appendix A, on page 26, for more details.
MAINTENANCE
There is no
All surfaces pitch to a deep-
LIFT UP TOP
HATCH TO EASILY
ACCESS COIL
AND PLENUM
TOP HATCH
COIL CLEANING
The coil and fan plenum are located outside the
product area to keep food fluids from entering, diminish
downtime, and reduce shrink.
make certain fan plenum is properly closed after cleaning
to avoid air leaks.
21
If cleaning is required,
HONEYCOMB
REAR
HONEYCOMB
RETAINER
SCREW
LOOSEN SCREWS IN
REAR HONEYCOMB
RETAINER AND
TWIST HONEYCOMB
OUT
CLEAN HONEYCOMB
Advertisement
Table of Contents
