Fuel Filter Replacement; Deck Removal - Snapper ZMT2500KH SERIES 0 Safety Instructions & Operator's Manual

Section 4 - MAINTENANCE
3.5 ANNUALLY (END OF EACH SEASON)
(Continued from previous Page)
3.5.2. FUEL FILTER
Service fuel filter as instructed below. Turn key to
"OFF" position. Engine MUST be stopped and
MUST be cold before removing filter. Clamp fuel
line to prevent fuel spillage or perform filter change
when fuel tank and fuel line are empty.
WARNING
Allow engine to cool for at least ten minutes before
performing service or maintenance. DO NOT smoke
near fuel components when performing service or
maintenance. DO NOT perform service and
maintenance near an open flame. Wipe off any
spilled fuel before starting engine. DO NOT run
engine indoors.
1. Remove fuel line clamps from fuel filter.
2. Remove fuel lines from filter. Discard filter.
3. Install new fuel filter. Reinstall fuel line clamps.
See Figure 3.8.
POSITION DECK
LIFT LEVER IN
HIGHEST CUTTING
POSITION, PLACE
WOODEN BLOCKS
UNDER FRONT &
REAR OF DECK
FIGURE 3.9
REMOVE
LINE
CLAM PS
REMOVE
CLAMP FUEL FUEL
LINE TO FILTER
PREVENT
SPILLAGE
FIGURE 3.8
3.6 DECK REMOVAL
Move power unit/mower deck to an area where the
mower deck is to be disconnected. Turn engine "OFF"
and remove key from switch. Remove spark plug wire(s)
and secure away from spark plug(s). Engage parking
brake.
1. Move deck lift lever and set the mower deck to the
highest cutting position. See Figure 3.9.
2. Place a wooden block under the front and rear edge
of the mower deck.
3. Move deck lift lever and set the mower deck to a
lower cutting position until deck rests on wooden blocks.
See Figure 3.9.
17