Table of Contents
Advertisement
ACCESSORIES
Accessories
for this unit are available at the store the unit was purchased.
ASSEMBLY
To Add Oil To Pump
_=_f_q_
DO NOT A3"I'EMPT TO OPERATE THIS AIR
COMPRESSOR
WITHOUT
FIRST ADDING OIL TO THE
CRANKCASE.
Serious damage can result from even limited operation
unless filled with oil and broken in correctly. Make sure to closely follow
initial start-up procedures.
_
COMPRESSORS
ARE SHIPPED WITHOUT OIL. A small
amount of oil may be present in the pump upon receipt
of the air compressor, This is due to plant testing and does not mean the
pump contains oil.
Multi-Viscosity
motor oils, like lOW 30, should not be
used in an air compressor. They leave carbon deposits
on critical components,
thus reducing performance
and compressor life.
Use air compressor
oil only.
NOTE: Use an air compressor oil such as SAE-30 (API CG/CD heavy duty
motor oil). Under extreme winter conditions use SAE-10 weight oil.
1.
Place unit on a level surface.
Drain tank to release
air pressure before
removing the dipstick.
_Make
sure air vent (B)
in dipstick is free from
debris. If air vent is blocked pressure
can build in crankcase
causing damage
to air compressor
and possible personal
injury.
2.
Remove dipstick (A) and slowly fill
crankcase with oil. C
is 8 fluid ounces (236.6 ml). Oil level
should be at the + (full) mark on the
dipstick.
NOTE= If the oil is added too quickly, it will overflow and appear to be full.
3.
Replace dipstick.
9- ENG
D24064
Advertisement
Table of Contents
