NordicTrack C1900 831294072 User Manual page 14

When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash and a
series of tones will sound, in addition, if the speed
and/or incline of the treadmill is about to change,
the Speed display and/or the Incline/Distance dis-
play will flash to alert you, When the first segment
is completed, aft speed settings will move one col-
umn to the left, The speed setting for the second
segment will then be shown in the flashing Current
Segment column and the treadmill will automati-
cally adjust to the speed and incline settings for
the second segment, Note: if all of the indicators in
the Current Segment column are lit after the speed
settings have moved to the left, the speed settings
will move downwardso that only the highest indi-
cators appear in the program display, if some of
the indicators in the Current Segment column are
not lit when the speed settings move to the left
again, the speed settings will move back up,
The program wiii continue in this way until the
speed setting for the last segment is shown in the
Current Segment column and the last segment
ends, The walking belt will then slow to a stop,
if the speed or incline setting is too high or too low
at any time during the program, you can manually
override the setting by pressing the Speed or
Incline buttons, Eve n, few times a Speed button is
pressed, an additional indicator wiii light or darken
in the Current Segment column (if any of the
columns to the right of the Current Segment col-
umn have the same number of lit indicators as the
Current Segment column, an additional indicator
may light or darken in those columns as well,)
Note: If you manually override the speed or in-
cline setting, when the next segment begins,
the treadmill wit1 automatically adjust to the
speed and incline settings for the next seg-
ment.
To stop the program temporarily, press the Stop
button, The Time/Pace display wiii begin to flash,
To restart the program, press the Start button or
the Speed + button, The walking belt will begin to
move at 1 mph, When the next segment of the pro-
gram begins, the treadmill will automatically adjust
to the speed and incline settings for the next seg-
ment, To end the program, press the Stop button,
remove the key, and then reinsert the key,
Follow your progress with the displays.
See step 5 on page 12,
Measure your heart rate if desired.
See step 6 on page 12,
Turn on the fans if desired.
See step 7 on page 13,
When you are finished exercising, remove the
key.
Stop onto the foot rails and make sure that the in-
cline of the treadmill is at the lowest level, The in-
cline must be at the lowest JeveJwhen the
treadmill is raised to the storage position, Next,
remove the key from the console and put it in a se-
cure place, Note: If the displays and indicators
on the console remain Jit after the key is re-
moved, the coneote is in the "demo" mode.
See page 22 and turn off the demo mode.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the off position and
unplug the power cord,
14