Fisher & Paykel OB60 Series Installation Instructions And User Manual page 41

'door' with AUTO flashing
5
The oven door has been opened after the pyrolytic cycle has been selected.
The cycle is cancelled.
What to do:
Close the door. P0•00 will show in the display with the letter P and AUTO flashing.
Turn the function knob to 0 and start again.
If after 5 minutes the door has not been closed 'door' flashes and a beep sounds for 30 seconds.
What to do:
Close the door, press any button to silence the beeping and start again.
F0.00 with AUTO flashing
6
The pyrolysis cycle has been stopped and then started again when it was well advanced. The
message is displayed after about 10 minutes and the cycle is cancelled.
What to do:
Turn the function knob to 0.
Wait for the oven to cool down completely before restarting the pyrolytic cycle.
30 F0 or 30 F1 appear during the pyrolytic cycle
7
Oven temperature sensor broken or not working properly.
The cooling fan stays on and if the pyrolytic cycle is in progress the door remains locked.
What to do:
Turn the oven function selector to O. A 30 minute countdown will start.
Wait for the countdown to finish. The fan switches off and the door, if locked, unlocks.
Wait for the oven to cool down completely.
Disconnect the oven from the mains and contact your Authorised Service Centre because the
oven can no longer be used.
Note: If the function selector is not turned to O, the cooling fan will continue to work and the
oven door, if locked, remains locked.
'do•Lo' appears during the pyrolytic cycle
8
What to do:
Turn the function knob to O
Wait for the door to unlock. This happens automatically when the temperature inside the oven
drops below 300 O
Set the clock
Wait for the oven to cool down completely before using it again.
C. 12.00 will flash.
Care and cleaning
39