Fisher & Paykel OB60 Series Installation Instructions And User Manual page 39

Electronic and pyrolytic models
Hide thumbs Also See for OB60 Series:
Table of Contents

Advertisement

Using the pyrolytic self-clean function
Important!
Do not use oven cleaners, any degreasing cleaners, or oven liners.
Do not clean the door or cavity seals, or use any oven cleaning products on the seals.
Do not use your oven to clean miscellaneous parts.
Make sure the room is well ventilated.
Move any caged birds to another closed and well-ventilated room, as some birds are extremely
sensitive to oven self-cleaning fumes.
If there are cracks or flaws on the oven door glass (inside or outside), if the seals are ruined or
worn, or if the door does not close properly, uplug the oven and contact your Authorised Service
Centre.
Note: use this function only when the oven needs cleaning. Do not wait until it is very dirty.
Remove the oven shelves and all other cookware/utensils.
1
Wipe up large food spills. Failure to do so may discolour the enamel.
2
Close the oven door.
3
Turn the function knob to
4
letter P flashing.
Press button 3. P1.30 (pyrolytic self-clean cycle of one hour
5
30 minutes) will appear, and the door locked indicator and
temperature lights will be lit.
Note: you can adjust the self-clean cycle time between one
hour 30 minutes and three hours, depending on how dirty
the oven is. To do this, press button 2 and then button 5 or 6.
The self-clean cycle starts immediately, and the time remaining is displayed.
When the oven has finished cleaning, PO.OO will appear with AUTO flashing.
PO.OO will remain until the oven temperature drops below 300
will flash and the door locked and temperature indicator lights will go out.
Turn the function knob to O. The time will appear.
6
Wait for the oven to cool down completely.
7
Remove the grey ash with a small brush or damp cloth, then wipe out the oven with a clean
8
damp cloth, and dry with a clean lint-free cloth.
Important!
Wait for the oven to cool down completely before using it again.
To stop the self-clean cycle, turn the function knob to O. We do not recommend stopping the
cycle, and then starting it again.
. PO.OO appears with the
Care and cleaning
I I
1
2
Figure 32 Self-clean cycle displays
o
C. Then AUTO and the letter P
37
6
3
4
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents