Fisher & Paykel OB24SDPX Installation Instructions And User Manual page 10

2
Programmer
Temperature
➀
➁
or
➁
➂
10
SETTING THE COOKING
Function
knob selector knob
4 5 6
2a 2b
NOTE: The temperature knob (potentiometer) turns to right and left only
to symbols + and -. Forcing the turning could damage the temperature
knob.
The temperature set is shown on the electronic program display and can be var-
ied, with 5 °F (5 °C) intervals, by means of the temperature knob (potentiometer)
or the program keys.
During cooking the oven temperature (°F or °C) is measured by a sensor inside
the cavity and is shown on the program display until set temperature is reached.
If set temperature is less than inside oven temperature, the display shows the
set temperature.
1.
SELECTING THE COOKING FUNCTION
Turn the selector knob to the cooking function required
The pre-set temperature appears on the program display. °
on the display for 3 seconds. The heating elements start cooking immedi-
ately.
2.
SETTING THE COOKING TEMPERATURE
Turn the potentiometer knob clockwise to increase the temperature or
anticlockwise to reduce it.
The maximum temperature which can be set is 480 °F (250 °C) while the
minimum temperature is 120 °F (50 °C).
or use the program keys in the following way:
The temperature can be changed when °
F C
2a. If ° or ° is not flashing press key 4 of the program.
2b Press key 6 to increase the temperature or key 5 to reduce it.
The maximum temperature which can be set is 480 °F (250 °C) while the
minimum temperature is 120 °F (50 °C).
F C
Note: When ° or ° becomes steady the value shown on the display indicates
the oven cavity temperature until set temperature is reached. If set temperature
is less than inside oven temperature, the display shows the set temperature.
Caution: If a temperature below the minimum value (120 °F or 50 °C) is set the
system switches off automatically and
In this case repeat the procedure from point 2.
3.
SWITCHING OFF
Turn the selector knob to position
time.
(ONLY FOR THE COOKING FUNCTIONS)
F C
or ° is flashing on the display.
OFF
appears.
0
(OFF). The program display shows the
F C
or ° flashes