Electrical Requirements; Wiring Instructions; Wiring Requirements - Fisher & Paykel OD301 Series Installation Information

ELECTRICAL REQUIREMENTS

The electrical voltage and frequency that is correct for this oven is stated on the serial
number plate located inside the top vent. It is the customer responsibility to ensure that
this oven is connected to the correct electrical supply.
WARNING : The oven must be connected to a permanent and
grounded supply.
Maximum current draw and Maximum Load:
240V
Double : 38.2 A 9.2 kW
Single : 21 A 5.1 kW

WIRING REQUIREMENTS

A circuit breaker appropriate for the product is recommended.
The electrical supply conduit must be securely clamped in the cable clamp located inside
the product.
Do ensure a suitable disconnection switch is incorporated in the permanent wiring,
positioned to comply with the local wiring rules and regulations. A means of disconnection
with at least a 3mm air gap contact separation in all poles must be incorporated into the
fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for the
following variation. A means of disconnection from the supply having an air gap separation
in all active (phase) conductors must be incorporated in to the fixed wiring.
220V
35 A 7.7 kW
19.5 A 4.3 kW

WIRING INSTRUCTIONS

1. Remove the top panel from the product.
2. Feed the oven electrical supply cable through the grommeted hole on the
o
45 corner at the rear of the product. Then thread that cable through the
burst hole and the wiring clamp.
3. Connect the electrical supply cable to the earth post and mains terminal
block as indicated on the diagram below.
It is recommended to use an appropriate terminal lug to connect the cable to
the mains terminal block and earth post.
4. Secure the wiring clamp and re-fit the top panel.
PAGE 6 OF 8
wiring clamp