Magnavox 47MF439B User Manual page 21

7 Install channels
The first time you setup yourTV, you are prompted to select a menu
language and to installTV and digital radio channels (if available).This
chapter provides instructions on how to reinstall and fine-tune channels.
Select your menu language
1 Press MENU on the remote control and select [Installation] >
[Language].
TV menu
Installation Language
2
Select a language and press OK to confirm your choice.
3 Press 4 to return to the [Installation] menu.
4 Press MENU to exit.
Set your location to home
You can set the location ofyourTV to home or retail store. Choose
home so that you can change the predefined settings for picture and
sound.
1 Press MENU on the remote control and select [Installation] >
[Preferences] > [Location].
2
Select [Home] and press OK to confirm your choice.
3 Press 4 to return to the [Installation] menu.
4 Press MENU to exit.
Automatically install channels
Before you install channels, ensure that you are registered with your
cableTV provider and that your equipment is correctly connected.
1 Press MENU on the remote control and select [Installation] >
[Channels] > [Autoprogram] > [Start now].
Installation
Channels Autoprogram
Autoprogram
2
3
Press OK to start the installation.
• If you run [Autoprogram] on locked channels, you must to
enter your PIN code.
• If you have forgotten your PIN, reset it (see 'Set or change
your PIN' on page I6).
Select [Cable] or [Antenna] and press OK.
TV installation
4
• When [Antenna] is selected, the TV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
• When [Cable] is setected, theTV detects signals supplied
by cable. It searches for NTSC, ATSC, and QAPI modulated
channels available in your area.
• When complete, this message appears [Channel search
completed.].
Follow the on-screen instructions to complete the installation.
Optimize the signal quality from your
antenna
You can optimize your signal quality by tuning in ATSC channets with
weak signals, and adjusting the antenna.
1 Press MENU on the remote control and select [Installation] >
[Channels] > [Installation mode] mode.
2 Select [Antenna] and press 4 to confirm your choice.
3
Press A and _ to enter [Weak channel installation].
4 Highlight a channel from the list of TV channels and press the green
color button on the remote control.
L_ The signal strength for the channel is displayed.
EN 21