Fisher & Paykel DISHDRAWER DD24 User Manual page 34

T oub eshooting
Continuous A fault has occurred. Refer to the 'Fault codes' section.
beeping
Intermittent DishDraweP _ is in pause Close the DishDraweP _and press the Ht
beeping mode, button.
Power supply is not Connect the power supply.
connected.
The drawer is not closed Ensure the drawer is firmly closed.
DishDraweP_wi[[
not start
Water under the
drain filter
Excess water in the
DishDrawer _
is on. down the _/@ button until the@ symbol
disappears from the L£D screen or the light
above thee/@ button disappears.
bH button not pressed, Press the HI button,
This is normal and needs no action.
Drain hose(s) bent or Straighten the drain hose(s),
kinked.
Blocked filters. Clean the filter plate/drain filter. Refer to the
'User maintenance instructions' section,
Water marks on the
dishes
Rinseaid depleted. Refill the rinse aid dispensen
Rinseaid setting too low. Increase the rinse aid setting.
DishDraweP _ overloaded/ Refer to the section on loading.
incorrectly loaded.
DishDrawe¢ _ Some foods, like tomato Pre-nnse dishes before placing in the
interior is stained based products, may DishDrawePL Alternatively, using the Rinse
stain the inside of the programme after adding the dishes may
DishDrawePL minimise staining,
Dishes did not dry Incorrect loading, Ensure the dishes are not nesting together,
Rinse aid depleted, Refill the rinse aid dispenser,
Rinse aid setting too low, Increase the rinse aid setting,
Eco wash programme use& Choose a standard wash programme,
No detergent Detergent dispenser was Clean the dispenser and ensure the
dispensed wet when Ioaded_ dispenser is dry when adding detergent.
Excessive motor The filter plate and/or spray Refer to the'User maintenance instructions'
noise arm is incorrectly placed, section for details on correct placement.
No water in the motor area. This usually occurs on the first use or when
the DishDraweP _ has not been used for
long periods of time. Run the DishDraweP _
through a wash programme,