Table of Contents
Advertisement
- Progressive Scan (Y Pr/Cr
Pb/Cb connection only)
Progr_sswe ScanVideo provides the highest quality pictures
If you are using the ComponentVideo
jacks, but are
connecting the DVD Player"to a standard (analog)
television, set Progressive Scan to Of[
If you are using the ComponentVideo
jacks for connection
to aTV or" monitor that is compatible with a progressive
scan signal, set Progressive Scan to On,
Notes:
-
ProgressiveScan only works when theVIDEO OUTPUT
switch on the rear panel is set to COMPONENT/
PROGRESSIVE SCAN.
-
ProgressiveScan only appears in the menu if the VIDEO
OUTPUT switch is set to COMPONENT/PROGRESSIVE SCAN.
- Make sure the TV'S Sync Mode setting is correct. For
example, on some Philips TVs,set "SYNC MODE'to
"SYNC
MODE 2."An incorrect Sync Mode setting will cause the
picture to shift off-center on the TV screen while using
Progressive Scan.Check your TV owner's manual for details on
correct Sync Mode settings.
Caution:
-
Once the setting for progressivescan output is entered, an
image will only be visibleon a progressivescan compatible TV or
monitor. If you set ProgressiveScan to On in error, you must reset
the unit. PressSTOPto stop any disc that is playing. Next, press
STOPagain and hold it for five seconds before releasing it.The
video output will be restored to the standard setting, and a
picture will once again be visible on a conventional analog TV or
monitor.
Sample
Frequency
To change the Sample Frequency setting, first select the
desired Digital Audio Output as indicated above.
I[ your receiver" or amplifier is NOT capable of handling
96KHz signals, select 48KHz, When this choice is made, this
unit will automatically convert any 96KHz signals to 48KHz
so your system can decode them,
I[ your receiver" or amplifier is capable of handling 96KHz
signals, select 96KHz, When this choice is made, this unit will
pass each type of signal through without any further
processing.
Language
Language
(Disc Audio, Disc Subtitle
and Disc
Menu)
Select a language for the disc's Menu, Audio and Subtitle.
Audio language and Subtitle language also can be adapted
using the On Screen Displa)4 Press the A/V buttons to
select an item, then press the 41_ bu|tons to choose a
setting in the On Screen Display (menu bar),
The change will be effective only ifithe language is available
on the Disc (as shown on Disc case).
Sound
-
Digital Audio Output
Each DVD disc has a variety of audio output options. Set
the player's Digital Audio Output according to the type of
audio system you use,
DOLBY
DIGITAL/PCM:
Select "DOLBY DIGITAL/PCM"
if
you connected the DVD Player's DIGITAL OUT
(COAXIAL
or" OPTICAL) jack to a Dolby Digital decoder
(or an amplifier or other equipment with a DMby Digital
decoder%
Stream/PCM: Select'Stream/PCM"
ifi you connected the
DVD Player's DIGITAL OUT (COAXIAL
or OPTICAL) jack
to an amplifier" or other equipment with a DTS decoder;
Dolby Digital decoder or MPEG decoder:
PCM: Select "PC[q" ifiyou connected the DVD Player's
DIGITAL OUT (COAXIAL
or OPTICAL) jack to an
amplifier or other equipment with linear PCM only (or" Mini
Disc (MD) recorder or Digital AudioTape (DAT) deck).
Menu Language
Select the language for the DVD Player's Menu,This is the
menu you see when you press the SYSTEM MENU button.
14
PREPARATION
Advertisement
Table of Contents
