Temperature Control - Fisher & Paykel TITAN CG602Q User Manual

Temperature control

Choose the control knob for the burner you want to use.
1
Press down and turn the knob anti-clockwise
2
all the way to the high
the knob for 5 seconds until the burner lights.
All the igniters will spark until the gas ignites
on the selected burner.
The flame can be adjusted anywhere between
3
the high symbol and the low
not regulate the flame between high and off.
If the cooktop/hob does not light
Check that you know how the flame failure device works (refer to page 4).
Check that the power is switched on allowing the electronic ignition to work.
Check the gas is turned on and coming out.
Check that the burner rings are placed correctly.
Clean electrode tips with a toothbrush and methylated spirits.
If the burner has not ignited with 15 seconds, stop operating the igniter and wait at least 1
minute before attempting a further ignition of the burner.
In the event of the burner flames being accidently extinguished, turn off the burner control and
do not attempt to re-ignite the burner for at least 1 minute.
Power failure
In the event of a power failure, the burners can be lit by holding a match close to the side of
the burner and turning the control knob to the high flame symbol . Wait until the flame is
burning all the way around the burner cap before adjusting.
Heating tips
When you need to boil, simmer or fry your food, first set the temperature to the high flame
symbol . Once your pan is boiling, reduce the temperature setting to maintain a steady heat to
cook your food through. This will reduce cooking time.
symbol. Hold down
symbol. Do
Flame adjust
(Titan knob shown)
3