TITAN MODELS (CG913 Series)
Temperature control
Choose the control knob for the burner you want to
1
use.
Press down gently and turn the knob anticlockwise to
2
the high position. You do not need to hold the knob
down.
All electrodes will spark until the selected burner
3
ignites.
Note: For the first burner selected there is a short
delay before the safety valve allows gas to flow to the
cooktop.
Adjust the flame anywhere between the High and
4
the Low positions. Do not adjust the flame between High and Off.
If the cooktop does not light
Check that the cooktop is plugged in and the power is switched on.
Check that the gas is turned on.
Check that the burner parts, including the burner cap, are positioned correctly.
Burner cap
Electrode
Allow two seconds for the safety valve to open when igniting
the first burner.
A dirty or wet electrode will prevent the burner lighting
efficiently. Clean electrodes with a toothbrush and methylated
spirits.
Burner ring
High
Correct assembly
Off
Burner
ON
light
Incorrect assembly
Electrode
Low
3