Fisher & Paykel CG905 Installation Instructions And User Manual
  1. Manuals
  2. Brands
  3. Fisher & Paykel Manuals
  4. Cooktop
  5. ELBA CG905 Series
  6. Installation instructions and user manual

Fisher & Paykel CG905 Installation Instructions And User Manual

Gas cooktops
Hide thumbs Also See for CG905:
Table of Contents

Advertisement

Quick Links

See also: User Manual and Installation Instructions
Gas cooktops
Installation instructions
CG604 & CG905 models
User guide
and
GB IE

Advertisement

Table of Contents
loading

Related Manuals for Fisher & Paykel CG905

Summary of Contents for Fisher & Paykel CG905

  • Page 1 Gas cooktops Installation instructions CG604 & CG905 models User guide GB IE...

  • Page 3: Table Of Contents

    Contents Safety and warnings Installation instructions Introduction Using your cooktop Cooking guidelines and cookware Care and cleaning Troubleshooting Warranty and service Important! SAVE THESE INSTRUCTIONS The models shown in this document may not be available in all markets and are subject to change at any time.

  • Page 4: Safety And Warnings

    Safety and warnings Installation Electrical Shock Hazard Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply. Connection to a good earth wiring system is absolutely essential and mandatory. Alterations to the domestic wiring system must only be made by a qualifi ed electrician.

  • Page 5: Important Safety Instructions

    Safety and warnings Important safety instructions! Installation This appliance shall be installed in accordance with the applicable regulations in force and only used in a well ventilated space. Read the instructions before installing or using this appliance. Please make this information available to the person installing the appliance as it could reduce your installation costs.
  • Page 6 Do not touch the cooktop components, burners, trivets, pan supports or the base when hot. Before cleaning, turn the burners off and make sure the whole cooktop is cool. Failure to follow this advice may result in serious injury. Fire Hazard Never leave the appliance unattended when in use.
  • Page 7 Do not use an asbestos mat or decorative covers between the flame and the saucepan as this may cause serious damage to your cooktop. Do not place aluminium foil or plastic dishes on the cooktop burners. Do not let large saucepans or frying pans overlap the bench as this can deflect heat onto your benchtop and damage the surface.

  • Page 8: Installation Instructions

    Installation instructions Cooktop and cutout dimensions overall width of cooktop overall depth of cooktop height of chassis below top of bench width of chassis depth of chassis overall width of cutout overall depth of cutout corner radius of cutout distance from right edge of cutout to...
  • Page 9 Ensure there is an earthed power outlet within 900 mm of the rear right-hand corner of the cooktop. The outlet should be accessible with the cooktop installed. There may be cabinetry at the minimum clearance ‘A’ on one side of the cooktop, but the other side (left or right) MUST be kept clear.
  • Page 10 (within 900 mm from the rear right of the cooktop, see dimension E in ‘Clearances’)
  • Page 11 Electrical connection requirements This appliance must be connected to a 220-240 V 50 Hz power supply only and earthed via the power supply cable. In the United Kingdom, the suitably earthed three-pin plug must be protected by a 3 A fuse. A suitable isolating switch providing full disconnection from the mains power supply must be incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.
  • Page 12 Connecting the cooktop to the gas supply Important! This cooktop is supplied factory-set for Natural gas, but is suitable for installation with either Natural gas or LPG, provided the injectors appropriate for the gas type are installed. Refer to section ‘Gas supply and gas rate summary’ for nominal ratings and appropriate injector sizes, and to section ‘Converting to a different gas type’...
  • Page 13 Note: if installing the conical adaptor, remember to fit the fibre washer supplied between the adaptor and the elbow. Ensure the fibre washer (supplied) is located between the elbow (supplied) and cooktop gas inlet (Figs. 2a and 2b). Failure to use this washer will cause the connection to leak. Tighten the floating nut to firm finger tight, plus an additional ¼...
  • Page 14 Installation instructions BS 21/ISO 7-1 R 1/2” Elbow Fibre washer Fig.2a Gas connection to the cooktop: elbow with 1/2” taper male thread (CG604DWFC and CG905DWFC models) ISO 228-1 G 1/2” BS 21/ ISO 7-1 R 1/2” Fibre washer Elbow Fibre washer...
  • Page 15 Leak-testing and flame-testing the cooktop Important! The operation of the cooktop, including the ignition system, must be tested before installation is complete. If, after following the instructions below, satisfactory performance cannot be obtained, contact the local gas authority or your local Authorised Service Centre for advice and assistance.
  • Page 16 Reset the venturi. Loosen the venturi screw, move the venturi towards the injector approx. 2 mm. Refit the hob tray on the cooktop, repeating steps 6 and 7 in reverse. Check insulation resistance and earth continuity. Reconnect the cooktop to the power supply.
  • Page 17 Adjusting the minimum burner setting This has been adjusted at the factory for Natural gas but may need adjusting for local conditions. When converting to LPG, the minimum setting MUST be re-adjusted for each burner. To adjust the minimum setting, you will need a Ø 2.5 x 45 mm screwdriver. Light the burner and set the control dial to its minimum.
  • Page 18 Installation instructions (g/h) rate (kW) rating Nominal marking Injector (kW) rating Nominal marking Injector (g/h) rate (kW) rating Nominal marking Injector (kW) rating Nominal marking Injector (g/h) rate (kW) rating Nominal marking Injector (kW) rating Nominal marking Injector (g/h) rate (kW) rating Nominal...
  • Page 19 Have you securely fastened the cooktop to the bench with the supplied brackets? All models except CG905DWAC: Have you used the supplied elbow (and conical adaptor if required) and fibre washer(s) to connect the gas to the inlet on the cooktop? Have you leak-tested all connections?

  • Page 20: Introduction

    About your new cooktop Thank you for buying a Fisher & Paykel gas cooktop. Once it is installed and ready to use, you will want to know everything about it to make sure you get excellent results right from the start.

  • Page 21: Using Your Cooktop

    Releasing the dial too soon will extinguish the flame. Adjust the flame anywhere between HIGH and LOW. Do not adjust between HIGH and O (OFF). After use, always turn the dials to O (OFF). Using your cooktop OFF (closed valve) NEVER cook or leave the dial...
  • Page 22 If after trying again the burner still does not light, check that: the cooktop is plugged in and the power supply is switched on there is no power failure in your home or neighborhood...
  • Page 23 The gas supply will be cut off, even if a burner is in use. The cooktop cannot be used if there is a power failure. Wait until power is restored. If a control dial is still turned on when the power is restored, the corresponding ‘Burner On’...

  • Page 24: Cooking Guidelines And Cookware

    Cooking guidelines and cookware Cooking guidelines Important! Never leave the cooktop unattended when in use. Boilover causes smoking and greasy spills that may ignite. Take care when deep-frying: oil or fat can overheat very quickly, particularly on a high setting.
  • Page 25 Using a wok Use your wok only on a wok burner. On CG604DWFC and CG905DWFC models, a wok must always be used with the wok stand supplied. See Fig.18. The centre pan support of CG905DWAC models is shaped to take a traditional wok with a round base, but you may also use a wok stand for extra stability (not supplied, purchased optionally).

  • Page 26: Care And Cleaning

    Do not use abrasive cleaners, cloths or pads to clean any part of your cooktop. Some nylon scourers may also scratch. Check the label. Make sure that no cleaner residue is left on any cooktop part; when heated, these could stain the cooktop.
  • Page 27 Contact your local Authorised Service All gas Centre to perform a thorough check on all components of the gas components on the cooktop. cooktop For Authorised Service Centre details, see Once every your Service & warranty book or contact Customer Care.
  • Page 28 The wok support goes in the centre, over the wok burner. The other two pan supports are interchangeable, but need to be rotated to match the rounded corners of the cooktop base. Fig.19 Correct positioning of pan supports (CG905 models)
  • Page 29 Replacing the burner parts correctly Semi-rapid, rapid, and auxiliary burners Flame spreader Wok burner with cast iron cap and ring (CG604DWFC and CG905DWFC models) Fit the flame spreader to the housing as shown by the arrow in Fig.22 following. Make sure the burner is not able to rotate.
  • Page 30 Care and cleaning Brass wok burner (CG905DWAC models only) Each part of the brass wok burner has locating pins to help you to assemble it correctly after cleaning. See Fig.23 below. Note: the brass parts of your wok burner will change colour with use. However, this will not affect performance and you can clean the brass parts with a brass cleaner.

  • Page 31: Troubleshooting

    The gas pressure may not be at the correct level. Check this with your service person or installer. Your cooktop may not be set up for the gas you are using. Check this with your service person or installer. Check the burner parts are clean and dry.
  • Page 32 Models with auto-reignition (CG905DWAC) The gas supply will be cut off, even if a burner is in use. The cooktop cannot be used if there is a power failure. Wait until power is restored. If a control dial is still turned on when the power is restored, the corresponding ‘Burner On’...

  • Page 33: Warranty And Service

    Authorised Service Centre, Customer Care, or contact us through our local website listed on the back cover. This cooktop has been designed and constructed in accordance with the following codes and specifications: Safety requirements of EEC Directive “Gas” 90/396...
  • Page 36 www.fi sherpaykel.co.uk www.fi sherpaykel.ie Copyright © Fisher & Paykel 2009. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available.

This manual is also suitable for:

Cg604

Table of Contents

Save PDF