Contents Introduction Safety and warnings Using your cooktop Care and cleaning Troubleshooting Warranty and service Gas rate summary Important! SAVE THESE INSTRUCTIONS...
About your new cooktop Thank you for buying a Fisher & Paykel gas cooktop. Now that it is installed and ready to use, you will want to know everything about it to make sure you get excellent results right from the start.
If the electrical supply cord is damaged, it must only be replaced by an authorised person. Ensure that the electrical connection plug is accessible after installation. Where this gas cooktop is installed in marine craft or in a caravan, it shall not be used as a space heater.
If the cooktop does not light If the cooktop does not light, check that: The cooktop is plugged in and the electricity is switched on. The gas is turned on. The electrodes are sparking. If the electrodes are not sparking, they may be dirty or wet. Clean them with a toothbrush and methylated spirits, as shown in Fig.
Electricity failure If there is an electricity failure, you can still use your cooktop. Light the burners by holding a match close to the side of the burner and turning the control knob to the High position. Wait until the flame is burning evenly before adjusting.
Using your cooktop General guidelines To get the best out of your cooktop, follow these simple suggestions: Use saucepans with thick flat bottoms. Food in a saucepan with an uneven bottom will take longer to cook. Fig.10 Efficient and inefficient saucepan bottoms Do not let large saucepans or frying pans overlap the bench as this can deflect heat onto your benchtop and damage the surface.
Page 9
Important! Prolonged cooking with the griddle at high temperatures may damage the cooktop. Cleaning a cast-iron griddle Leave the griddle to cool before cleaning. Scrape away any food residue and wash in warm soapy water.
Do not clean cooktop parts in a self-cleaning oven. Do not use a steam cleaner. After cleaning, replace the parts correctly on the cooktop, as shown in Fig. 13. When replacing the burner rings, turn the rings until the positioning teeth are placed correctly.
Always apply minimal pressure with abrasive cleaners. Remove spills as soon as the cooktop is cool to avoid the soil becoming burnt on. Reassemble the burner parts correctly. Never use harsh/abrasive cleaning agents as they will damage the stainless steel finish.
The gas pressure may not be at the correct level. Check with your service person or installer. Your cooktop may not be set up for the gas you are using. Check this with your service person or installer. Check the burner parts are clean and dry. Check the assembly and make sure the burner cap is sitting flat.
Before you call for service or assistance ... Check the things you can do yourself. Refer to the installation instructions and your user guide and check that: Your product is correctly installed. You are familiar with its normal operation. If after checking these points you still need assistance, please refer to the Service & Warranty book for warranty and after-sales service details or contact us through our website: www.fisherpaykel.com Product details...
Need help?
Do you have a question about the CG603, CG903 and is the answer not in the manual?
Questions and answers