Fisher & Paykel FREESTANDING COOKER OR120 User Manual page 13

Notes:
Flexible hoses can be used where the sited ambient temperature of the hose does not exceed
70°C. These hoses must be manufactured in accordance with BS669 part 1 and be of the correct
construction for the type of gas being used.
Gas hoses designed for natural gas MUST NOT be used for supplying LPG gas (LPG gas hoses can
be identified by a either a red band or stripe on the rubber outer coating of the hose).
The hose should not be crushed or trapped or be in contact with sharp or abrasive edges. It
should also not be subjected to corrosion by acidic cleansing agents.
To connect the gas supply:
Fit the 1/2" BSP (female) connector (supplied with the cooker in a separate kit) to the gas inlet at
1
the rear of the cooker interposing the gasket. Check the correct positioning of the connector as
shown and always use two suitable spanners (Fig 6b).
Connect the gas supply to the gas inlet at the rear of the cooker. If the pipe has to cross the
2
cooker, it must be positioned under the protected area of the cooker (see Fig 6a)
To avoid damage to the appliance gas rail
3
inlet pipe tighten the fittings using two
suitable spanners (Fig. 6b).
Using a suitable leak detection fluid solution
4
(e.g. Rocol) check each gas connection one
at a time by brushing the solution over the
connection. The presence of bubbles will
indicate a leak. If there is a leak, tighten the
fitting and then recheck for leaks.
IMPORTANT!
Do not use a naked flame to test for leaks.
Cooker manifold
Manifold male
pipe fitting
1/2" G cylindrical
(ISO 228-1) male
Gasket ( * )
1/2" G cylindrical
(ISO 228-1) female
Connector ( * )
1/2" BSP (female)
( * ) Supplied with the appliance in a separate kit.
Installation instructions
11
Fig. 6a
Fig. 6b