Control Panel Features - Chicago Electric 94191 Assembly And Operation Instructions Manual

Grounding The Generator:
fIGuRE c
Note: It is recommended that only a trained and licensed electrician perform this proce-
dure.
Connect a #6 AWG grounding wire (not included) from the Grounding Terminal (9)
on the Generator to a grounding rod (not included) that has been driven at least 24
inches deep into the earth. The grounding rod must be an earth-driven copper or
brass rod (electrode) which can adequately ground the Generator.
(See figure c.)
Engine Ignition (2):
1.
using power from the Battery (45), insert the Ignition Key (65) and turn the Engine
Ignition to its "START" position. To start the Engine manually using the Starter Rope
(40A) and Starter Handle (41A), insert the Ignition Key and turn the Engine Ignition
to its "RuN" position. Then pull briskly on the Starter Handle. To stop the Engine,
turn the Engine Ignition to its "Off" position. Always remove the Ignition Key
when the Generator is not in use. (See figure d, next page.)
fuel Tank cap (34):
2.
(See figure d.)
120 Volt Ac Outlets (5):
3.
outlets to power 120 volt tools and equipment. (See figure d.)
for technical questions, please call 1-800-444-3353.
SKU 94191

cONTROl PANEl fEATuRES

Starts and stops the Gasoline Engine. To start the Engine
NEVER run the Engine with the Fuel Tank Cap removed.
The Generator is equipped with two 3-hole 120 volt AC
GROuNdING TERMINAl
(9)
#6 AWG GROuNdING WIRE
(NOT INcludEd)
GROuNdING ROd
(NOT INcludEd)
Page 10