GE Appliances PHS925ST2SS Owner's Manual page 38

Before Vou Call For Service...
Troubleshooting Tips
Possible Causes What To Do
Clock and timer do Plug on range is not completely . Hake sure electrical plug is plugged into a live, properly
not work inserted in the electrical outlet, grounded outlet.
A fuse in your home . Replacethe fuse or reset the circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly set. . See the Using the kitchen timer section.
Oven will notself-clean The oven temperature is • Allow the range to cool and reset the controls.
too high to set o self-cleon
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
The probe is plugged into . Remove the probe from the oven.
the outlet in the oven.
(on some modelsl
"Crackling" or
This is the sound of the . Thisis normal.
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
during a clean cycle
Excessive soil. . Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait until LOCKED/DOOR
goes off. After the oven cools, wipe up the
excess soil and reset the clean cycle.
Oven door will not Oven too hot. , Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning oven or Using steam clean section.
clean cycle
Oven was heavily soiled. , Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to be cleaned again.
"LOCKED" flashes The self-cleon cycle has been , Close the oven door.
in the display selected but the door is not
closed.
"LOCKED" is on The oven door is locked . Touch the CLEAR/OFFpad. Allow the oven to cool.
when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
"F--" and a number
or letter flash
in the display
You hove o function error code. , Disconnect all power to the range for at least
30 seconds and then reconnect power. If the function
error code repeats, call for service.
38