Installation
Instructions
IT] REMOVE THE REFRIGERATOR
DOORS(cont.)
r_
Remove the hinge cover on top of the
refrigerator
door by removing the Phillips-head
screws and pulling it up.
r_
using a 5/16" socket ratchet/driver,
remove the
bolts securing the top hinge to the cabinet. Then
lift the hinge straight up to free the hinge pin
from the socket in the top of the door.
For Ice and Water models, also disconnect
power cord and ground wire (not shown)
©
Remove the tape and tilt the door away from
the cabinet. Lift the door off the center hinge
pin. Ensure that the plastic hinge pin thimble
remains on the hinge pin or inside door hinge
pin hole located in the bottom of the door.
f/
[]
Set the door on a non-scratching
surface with
the inside up.
[] REMOVECENTERHINGE
Using a 5/16" socket ratchet/driver,
remove the
bolts securing the center hinge to the cabinet.
Set the hinge and bolts aside.
I_ REMOVEOPPOSITEDOOR
Follow the same procedure
on the opposite
door. There are no wires, water lines or center
hinge covers on the opposite side.
r41 REMOVE FREEZER DRAWER
Refer to the Removing the Freezer Drawer
section for instructions.
32