GE Appliances 25 Owner's Manual & Installation Instructions page 18

Installation
Instructions
Refrigerator
Models 21 and 25
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - Save these instructions for l ocal
inspector's use.
• IMPORTANT -Obse_e all
g overning
codes and
ordinances.
• Note to Installer - Be sure to leave these instructions with
the Consumer.
• Note to Consumer - Keep these instructions for future
reference.
• Skill level- Installation of this appliance requires basic
mechanical skills.
• Completion time - Refrigerator Installation
20 minutes
Water Line Installation
S0 minutes
Anti-Tip Bracket Installation
20 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door, see Step 1 in the
Reversingthe Door Swing section.
• To remove the freezer drawer, see the Removing the
FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
(ON SOME MODELS)
If the refrigerator has an icemaker,it will have
to be connected to a cold water line.A GEwater supply kit
(containing tubing, shut-off valve,fittings and instructions)is
available at extra cost from
your dealer,by visiting our Website at GEAppliances.com (in
Canada at _v.GEAppliances.ca)or from Partsand
Accessories,800.626.2002 (InCanada 1.800.661.161@.
MATERIALS YOU MAY NEED
(not included)
Lag Bolts
Drill Bit Appropriate for Anchors
Anchor Sleeves
For Anti-Tip Bracket Mounted on CONCRETEFloors Only
TOOLS YOU MAY NEED
Adjustable Wrench
3/8" and 5/16" Socket
Ratchet/Driver
1/4" Outer Diameter
Compression Nut
and Ferrule (sleeve)
(icemaker models only)
Phillips-Head Screwdriver
3/32% 1/8" and 1/4" Allen
wrenches
1/8" Drill Bit and
Electric or Hand Drill
Tape measure
Pencil
1/4" Nut Driver
Wire Cutters
Level
18