Operation; Section 9: Start-Up Sequence; Honeywell Intermittent Pilot; For Your Safety - Read Before Lighting - Montigo R320 Installation & Maintenance Manual

1) Turn the wall switch ON
2) The blowers will start and within 10 seconds the glow
plugs will start to glow
3) If the pilot does not light the gas valves will turn the
glow plugs off after 20 seconds
4) This may need to be done three or four times to bleed

Honeywell Intermittent Pilot

A. This appliance is equipped with an ignition system that
lights the pilot burner automatically. Do not attempt to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
What To Do If You Smell Gas:
■ Do not try to light any appliance.
■ Do not touch any electrical switch; do not use any phone
in your building.
XG0770 - 020911

Operation

XW2008
STARTUP SeqUeNCe:
XW2040
Operation

FOR YOUR SAFeTY - ReAD BeFORe LIGHTING:

WARNING
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
all of the air out of the gas lines within the fireplace
5) Turning the switch OFF and then ON again will reset
this start up sequence
6) Once the pilots are burning the main burner will turn
on and the fireplace will be functional for a quick start up
on next use.
CAUTION
■ This fireplace has been set up at the factory for a
determined air volume though the venting system.
■ This fireplace will not operate unless the correct
air movement is detected by our control system..
■ Please consulted with your contact person at
Montigo should you have any problems with your
start up.
■ Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the Fire
Department.
C. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
R-Series R320-R420 Indoor Gas Fireplace
Section 9: Start-up Sequence
Page 23