Removing The Doors; Section 7:Removing & Installing The Door; Installing The Door - Montigo R320 Installation & Maintenance Manual

Removing the doors:

The doors are removed in a few simple steps.
Follow the steps below to remove the Vertical Door trim,
place the Door removal tool, and then remove the door.
Replace all the parts in reverse order.
Step 1. Remove the two (2) Vertical Trim pieces, (LH &
RH). Pulling firmly with your fingers, remove from the bottom
then the top. (See Figures 17 & 17a). Other side Typical.
Figure 17. (Remove LH Trim)
Step 2. Remove the supplied glass lifting tool from the
packaging. Place in the center of the Glass door as shown,
and activate the suction feature of the tool, Figure 17b.
NOTE: Read ALL the instruction supplied with the tool, and
follow the associated operating procedures.
Figure 17b. Supplied Glass lifting tools
XG0770 - 020911
Installation
Figure 17a. (Remove RH Trim)
R-Series R320-R420 Indoor Gas Fireplace
Section 7:Removing & Installing the Door
Step 3. Hold the Glass Removal Tools firmly, Lift the door
upward, into the top door frame, Figure 17c. Then pull the
bottom of the glass door downward, and tilt outward from
the bottom fireplace door frame. Figure 17d. NOTE: Read
ALL the instruction supplied with the tool, and follow the
associated operating procedures.
Lift Upward into
the door frame.
Figure 17c. (Lift the door
upward)
Figure 17e.

Installing the Door:

To install the door, follow Steps 1 and 4 above, (in reverse
order). Hook the top edge of the door frame into place. Lower
and rest the door frame in place and fasten the buckles.
See figures 28a and 28b.
XW2000
Lift Downward
& away from frame.
Figure 17d. (Lift the bottom
of the door outward).
Step 4. Still holding the Glass
Removal Tool firmly, remove the
door outward, and away from the
Fireplace, Figure 17e.
Step 5. Place the door in a safe
location while maintenance,
cleaning or other operation are
in progress.
N O T E : R e a d A L L t h e
instruction supplied with the
tool, and follow the associated
operating procedures.
Step 6 . T o replace, See Installing
the Door, Below.
NOTICE
Do not use ammonia based or abrasive
cleaners on the glass, they will
permanently etch the surface. Use an
approved gas fireplace glass cleaner
such as Kel-Kem or White off.
Page 21