Installing The External Wall Mounted Power Vent Module - Montigo R320 Installation & Maintenance Manual

Installing.the.external.wall.mounted.power.vent.
module
Step 1. Construct a frame for the termination opening to
meet the following requirements:
■ Opening Size must be: 14 1/2" x 14 1/2".
14 1/2"
(Opening)
Figure 6. Framing the Opening for Power Vent
Step 2. Insert the Power Vent Rough-in Box as shown in
Figure 6a. Fasten the Box securely in place with Screws
or nails, Figure 6a. Apply exterior sheathing and finishing
if required.
Framing
Figure 6a. Orientation, Placing the Power Vent Inner Box
Step 3. Next, remove the bottom collar and conduit mounting
frame as shown Figure 6b. (Place removed hardware in a
handy location for re-assembly).
Figure 6b. Installation of Rough-in Kit
XG0770 - 020911
Installation
14 1/2"
(Opening)
Fasteners
Rough-in Frame
R-Series R320-R420 Indoor Gas Fireplace
Step 4. Insert the conduit from the Power Vent Module into
the rough-in frame through the two top right entry holes.
Remove the nut from the supplied strain relief and place
as shown, Figure 6c.
Figure 6c. Installation of Power Vent Conduit
Step 5. Securely fasten bottom Collar pan into the Rough-in
frame using the existing hardware, (4-pcs). Tighten Strain
Relief nut onto Strain relief.
Step 6. Pull Power Vent Connector, (from behind) half-way
through supplied hole in conduit mounting frame, and snap
into place, (notches in two plastic wing clips. Orientation
not critical).
Figure 6d. (Installing Conduit connector & conduit mounting frame)
Step 7. Fasten Conduit mounting frame into place using
existing hardware, (6-pcs). (Coil conduit in behind cover.)
Strain Relief
Power Vent Conduit
Strain Relief
Nut
Strain Relief & tightened nut
Power Vent Conduit
Conduit
mounting
frame
Power Vent
Connector
Tightened hardware, 4-pcs.
Page 15