DigiDesign Pro Tools 8.0 Reference Manual page 747

To change the location of a sync point:
With the Selector tool, click at a point in a re-
gion and choose Region > Identify Sync Point. The
new location is identified as the sync point for
the region.
You can also move the location of a sync
point by clicking and dragging it. See "Drag-
ging Sync Points" on page 729.
Removing Sync Points
To remove a sync point, do one of the following:
Select the entire region and choose Region >
Remove Sync Point.
– or –
Choose the Time Grabber tool, then Alt-click
(Windows) or Option-click (Mac) the sync point
to delete it.
Displaying Sync Points
Sync points in audio regions may displayed or
hidden.
To disable the display of sync points in audio
regions:
Deselect View > Region > Sync Point.
To enable the display of sync points in audio
regions:
Choose View > Region > Sync Point.
Dragging Sync Points
You can drag a sync point to another position in
the audio region.
To set the sync point by dragging:
If you want the sync point to snap to the cur-
1
rent Grid value, enable Grid mode (see "Edit
Modes" on page 445).
Select the Time Grabber tool.
2
Drag the sync point to a new location.
3
Scrubbing Sync Points
While viewing an audio waveform can be a good
way to set a sync point, a waveform display may
not always reveal the desired spot in the audio
material. By scrubbing while moving the sync
point over an audio waveform, you can listen
for the exact location to place the sync point.
Sync Point Scrub cursor
Scrubbing a Sync Point
To scrub while dragging the sync point:
If you want the sync point to snap to the cur-
1
rent Grid value when you finish scrubbing, set
the Edit mode to Grid (see "Edit Modes" on
page 445).
Select the Scrubber tool.
2
Drag the sync point to a new location. The
3
sync point scrubs the audio as you move it.
Chapter 35: Arranging Regions 729