DigiDesign Pro Tools 8.0 Reference Manual page 481

To Loop Trim a looped region:
Select the Loop Trimmer tool.
1
Move the cursor over the top half of the
2
looped region (not over a Loop icon). The cursor
indicates the Loop Trimmer tool.
Loop Trimmer tool
Looped region
Trim the looped region.
3
Loop trimming a looped region
The number of loops increases or decreases to
fill the new length of the entire looped region.
Hold down the Start key on Windows, or
the Control key on Mac, while trimming to
trim in loop iteration increments.
Trimming a looped region does not trim any
underlying Fades.
Loop icon
To trim the source region (loop iteration) of a
looped region:
Select the Loop Trimmer tool.
1
Move the cursor over a Loop icon in the
2
looped region, or anywhere along the bottom of
the region. The cursor indicates the Trimmer
tool icon.
Trimmer tool
Looped region
Trim the start or end of the loop iteration.
3
Trimming a looped region
The number of trimmed loop iterations in-
creases or decreases to fill the original length of
the entire looped region.
Trimmed looped region
Chapter 23: Edit Modes and Tools
Loop icon
463