Jeep Navigation User Manual page 151

Automatic Transfer Call to Uconnect™ Phone
If you have an ongoing call on a cell phone which was
paired with Uconnect™ Phone before, and the navigation
radio is off, turn on the ignition and allow the
Uconnect™ Phone system to automatically transfer the
call. This may take a few seconds.
List All Paired Cellular Phone Names
1. Press the Uconnect™ Phone
2. Wait for the beep.
3. Say Uconnect SETUP.
4. After the following beep, say PHONE PAIRING.
5. After the following beep, say LIST PAIRED PHONES.
6. Uconnect™ Phone will play the phone names of all
paired cellular phones in order from the highest to the
lowest priority.
To "select" or "delete" a paired phone being announced,
press the Voice Command
or DELETE. Also, see next two sections for alternate way
of doing this.
Select another Cellular Phone
You may select phones in the Paired Devices menu.
(Refer to the Getting Started section in this manual for
more details).
button to begin.
This feature allows you to select and start using another
phone with Uconnect™ Phone.
The phone must have been previously paired to the
Uconnect™ Phone system that you want to use it with.
1. Press the Uconnect™ Phone
2. Wait for the beep.
3. Say Uconnect SETUP.
4. After the following beep, say SELECT PHONE.
NAVIGATION 139
button and say SELECT
button to begin.