Manual Stitch Length; Variable Needle Position - Janome Memory Craft 4400 Instruction Book

q w

• Manual stitch length

Press "–" or "+" to adjust the stitch length.
To decrease length, press "–".
To increase length, press "+".
The pre-programmed stitch length setting is suitable for
most of your sewing needs. However, you can change these
settings to accommodate different fabric characteristics or
achieve a desired effect.
Hold down "–" or "+" until you reach the desired setting.
* The reverse stitch length cannot be set longer than
2.5 mm (1/8˝).

• Variable needle position

These setting apply only to "straight" stitch patterns 01
through 04, and 11, 24, 29, 30.
You can adjust needle position of stitch patterns 01
through 04 and 11, 24, 29, 30 (see bottom of box on left).
When you press "–", the needle position will move to the
left.
When you press "+", the needle position will move to the
right.
q
w
e
e
Left (0.0)
Middle (3.5)
Rigth (7.0)
25