Winding The Bobbin - Janome Memory Craft 4400 Instruction Book

r
w
e
q
z
c
v b
t
y

• Winding the bobbin

z
Guide the thread around the thread guide.
x
Thread through the hole in the bobbin from the inside
to the outside.
x
* The additional spool pin is used to wind an extr
bobbin without unthreading the machine. To use,
insert the spool stand and the additional spool pin
in the hole. Place the felt and spool on the pin with
the thread coming off the spool as shown.
q
Hole for additional spool pin
w
Spool stand
e Additional spool pin
c
Put the bobbin on the bobbin winder spindle, and push
it to the right. With the free end of the thread held in
your hand, depress the foot control. Stop the machine
when it has made a few turns, and cut the thread close
to the hole in the bobbin.
y Bobbin winder stopper
v
Depress the foot control again. When the bobbin is
fully wound, it will stop automatiaclly.
b
Return the bobbin winder to its original position by
moving the spindle to the left, and cut the thread as
shown.
r Felt
t Spool
17