Quick Start - iHome iW2 air series User Manual

Quick Start

Power
1
Connect to power source
outlet
12V
Local iPod Audio Mode
1
Connect iPad/iPhone/iPod using iPod USB
sync cable
(iPod and aux-in play in parallel)
AirPlay Wireless Audio Mode
1
Verify that your iW2 speaker is successfully
connected to your Wi-Fi network.
(visit page 8 for connecting your iW2 speaker to your
Wi-Fi network)
status network setup
Connected
AirPlay Wireless Audio Mode
4
Select the iHome iW2 as your AirPlay
audio speaker
iHome iW2 speaker
Look for the AirPlay logo
to select your speaker
English
2
Press & hold
(3 seconds) to power unit ON.
2
Press
(visit pages 8-9 for Wi-Fi network configuration)
2
Press
status network setup
Not Connected
5
Press
use your iTunes, iPad, iPhone, or iPod
touch controls directly.
Press
or control volume on your AirPlay
source device.
power button
wait 20 seconds to allow system to startup
for iPod mode
for AirPlay wireless mode
buttons on the iW2 or
buttons to adjust volume
3 2
Press repeatedly to cycle between
standby and ON.
Press & hold (3 seconds) to turn iW2 OFF
Note: When the iW2 is OFF (not in
standby mode) you must press & hold
to begin using your iW2 speaker.
3
Press buttons on the iW2 or
iW2 remote, in iPod mode, to control
your iPod music.
Press buttons to adjust volume.
Note: Use iPod mode for both iPod
docking and Aux-in audio playback.
3
Launch iTunes or use your iPad, iPhone,
iPad touch. Verify iW2 and AirPlay source
device is on same Wi-Fi network.
AirPlay only works with iPod touch, iPhone, iPad,
or iTunes (Mac or PC)
!
Note: for AirPlay streaming:
iPad, iPhone, and iPod touch support
point-to-point audio streaming to one
AirPlay enabled speaker.
iTunes supports point-to-multipoint audio
streaming to up to three AirPlay enabled
speakers (performance depends on your
Wi-Fi network and environment).
5