Important; Precaution - Icom IC-PW1 Instruction Manual

IMPORTANT

READ THIS INSTRUCTION MANUAL
CAREFULLY
before attempting to operate the lin-
ear amplifier.

PRECAUTION

RWARNING HIGH VOLTAGE! NEVER
attach an antenna or internal antenna connector dur-
ing transmission. This may result in an electrical
shock or burn.
RWARNING! NEVER
by yourself. At least two persons must carry the linear
amplifier since it weights approx. 25 kg (55 lb).
RWARNING! NEVER
linear amplifier is grounded. Touching the linear ampli-
fier may result in an electrical shock.
RNEVER
apply AC voltage that exceeds the sug-
gested voltage. This could cause a fire or ruin the
IC-PW1/EURO.
RNEVER
use an extension cord with the AC power
cable. Extension cords may cause fire or electrical
shock.
RNEVER
let metal, wire or other objects touch any
internal part or connectors on the panel of the linear
amplifier. This will cause electric shock.
RNEVER
expose the linear amplifier or remote con-
troller to rain, snow or any liquids.
NEVER
allow children to play with the linear amplifi-
er or remote controller.
DO NOT operate the IC-PW1/EURO before adjusting
the [ALC adj1] and [ALC adj2] pots properly on the
rear panel of the linear amplifier.
Icom, Icom Inc. and the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
i
carry the linear amplifier
apply AC voltage until the
are registered trademarks of Icom Incorporated (Japan) in the United States, the
SAVE THIS INSTRUCTION MANUAL.
instruction manual contains important safety and oper-
ating instructions for the IC-PW1/IC-PW1EURO.
AVOID using or placing the linear amplifier or remote
controller in areas with temperatures below –10°C
(+14°F) or above +40°C (+104°F).
AVOID placing the linear amplifier or remote controller
in excessively dusty environments or in direct sunlight.
AVOID placing the linear amplifier against walls or
putting anything on top of the linear amplifier. This will
obstruct heat dissipation.
BE CAREFUL! The linear amplifier will become hot
when operating if continuously for long periods.
BE CAREFUL! Set the transceiver's (exciter's) RF
output power to less than 100 W, otherwise, the IC-
PW1/EURO will be damaged.
During maritime mobile operation, keep the linear
amplifier, remote controller and microphone as far
away as possible from the magnetic navigation com-
pass to prevent erroneous indications.
The IC-PW1/EURO cannot be used with the AH-2
AUTOMATIC ANTENNA TUNER
For U.S.A. only
CAUTION:
Changes or modifications to this device,
not expressly approved by Icom Inc., could void your
authority to operate this device under FCC regula-
tions.
This
HF
.