Closing A Job; Resuming A Closed Job; Powering Off The Cs1000 - RIDGID SeeSnake CS1000 Operator's Manual

Closing a Job

When you have completed the inspection, and added
all the desired images, text comments and video clips
needed, you can close the Job by pressing the
Manager Key and then, with "Close Job" highlighted
pressing the Select Key
with the job will be saved in a Report�
Figure 51 – Closing a Job

Resuming a Closed Job

If you have closed a job, you can still re-open it to
modify the contents� To resume a closed job:
1� Press the Job Manager Key
2� Use the down Arrow Key
"Resume Job" and press the Select Key
Figure 52 – Resume Job from Job Manager
28
Job
� All the data associated
to navigate to
�
3� Use the up and down Arrow Keys
navigate to the Job you want to resume� When
the blue outline is around the "Resume Job"
icon of the job you want to resume press the
Select Key
�
Figure 53 – Resuming a Closed Job
If a Job has been interrupted by the unit being shut
down unexpectedly, such as by a power outage, a
prompt asking you if you want to resume the job will
appear when the unit is started up again�

Powering OFF the CS1000

There are two ways to power OFF your CS1000� There
will be a 3 second power down countdown after you
press the power key� The power down countdown
can be cancelled by pressing any of the keys on the
CS1000's keypad�
• Pressing the Power Key
keypad�
• Pressing the Power Key
Abnormal Shutdown
In the event that the CS1000 is powered off abnormally,
the equipment will need to perform a systems check to
inspect and repair any damage the next time it powers
on� A systems check can take a few minutes� Events
that can require a systems check can be:
• An unexpected power outage during use�
• Unplugging the CS1000 when it is still ON�
Ridge Tool Company
to
on the CS1000
below the screen�