Connecting The Cs1000 ����������������������������������10 Accessories; System Connector ������������������������������������������������ 10 Transport And Storage; Additional Cs1000 Ports �������������������������������������� 10 Service And Repair - RIDGID SeeSnake CS1000 Operator's Manual

Opening the Front Cover
1� Locate the orange
on each side of the unit� Depress these buttons�
2� After depressing the buttons, you will feel the
cover release� Allow the cover to swing upward�
3� Raise the front cover to its uppermost position
where it will lock securely into place�
4� Lower the keyboard into its operating position�
5� (Optional) Use the Keyboard Latches to adjust
and secure the position of your keyboard� Pull
the red T-shaped latches toward you to lock the
keyboard into an upwardly angled position�
Figure 7 – CS1000 Cover Opened, Keyboard Lowered
Closing the Front Cover
1� Disconnect any and all connections (System
Cable, USB)�
2� Fold up the keyboard�
3� Keeping fingers clear of the Front Cover,
the orange Front Cover
sides of the unit to drop the cover to the lower
position� Press cover into place until it locks�
Figure 8 – Adjust the Keyboard using the Keyboard
Latch
10
Front Cover Release Buttons
depress
Release Buttons on both
Connecting the CS1000
NOTICE
Do not plug the System Cable into
the covered System Connector located below the
screen (shown with cover in Figure 8).
System Connector
1� Unwrap the SeeSnake System Cable from its
holder and insert the System Cable plug into the
matching SeeSnake System Connector on the
front edge of the keyboard�
Figure 9 – SeeSnake System Connector
2� To join the connectors, align the guide pin to the
guide socket, push the connector straight in and
tighten the outer locking sleeve� A guide ridge
molded into the top of the cable connector will
point up when the plug is correctly aligned�
Figure 10 – Connecting SeeSnake System Cable to
CS1000 System Connector
NOTICE
When connecting or disconnecting
the System Cable, turn only the locking sleeve. To
prevent damage to pins, do not bend or twist the
connector or cable.
Additional CS1000 Ports
NOTICE
The area behind the Connector
Cover, containing the USB Ports, Video Out Port
and Factory Interface Port is not internally sealed.
Keep the Connector Cover in place in wet or moist
conditions to prevent damage to the ports.
There are four ports located behind the red rubber
Connector Cover on the front edge of the keyboard�
Ridge Tool Company