Recycling Jobs; Main Menu - RIDGID SeeSnake CS1000 Operator's Manual

Close or Pause a Job
If you try to power OFF the CS1000 when a Job is
open you will be asked if you want to Close or Pause
the job before powering down� Your choice will depend
on what you want to have happen the next time you
power ON the CS1000�
Figure 54 – Close or Pause a Job
• Close Job and Power Down - Choosing this will
close the job and turn OFF the CS1000� If you
want to resume the job after this you will need to
select if from your Resume Job list�
• Pause Job and Power Down - Choosing this will
Pause the job and turn OFF the CS1000� The next
time you turn the CS1000 ON you will be asked
automatically if you want to resume your paused
job� This is especially convenient if you want to
take a quick break without using your batteries up
or when you want to move to a new inspection
entry point at the same job location�

Recycling Jobs

Jobs can be removed from the Job Browser by sending
them to the Recycle Bin�
1� Open the Job Browser by either pressing the:
• Menu Key
Arrow Key
icon � Then press
open the Job Browser�
• Job Manager Key
down Arrow Key
Reports�" Then press
open the Job Browser�
Ridge Tool Company
, and then using the right
, navigate to the Job Browser
the Select Key
, and then using the
, navigate to "Browse
the Select Key
2� Use the Select Key
the boxes in the left column� Check the Jobs you
want to recycle and uncheck the Jobs you want
to leave in the Job Browser�
Figure 55 – Select Jobs to Recycle
3� Then use the right Arrow Key
the Recycle button and press the Select Key
To exit the Job Browser without recycling any Jobs,
navigate to the Back button in the lower right corner,
Menu Key
press the
Configuring the CS1000
Once your CS1000 is configured it will save the settings
you have chosen and use them every time you start
the system up�

Main Menu

Press the Menu Key
to
to
Figure 56 – Main Menu
to check and uncheck
to navigate to
on the keypad�
to access the Main Menu�
�
29