Fader Assembly Removal - Rane SIXTY-EIGHT Operator's Manual

Fader Assembly Removal

1 Remove all five fader knobs.
2 Remove all four screws holding the
fader panel face plate.
3 Lift up the fader panel face plate and
set it aside where it can't get damaged.
4 Remove the two screws in the main
panel at the top of the fader assembly.
5 Remove the two screws at the front of
the fader assembly.
6 Slide the fader assembly out just
enough to see the three white and blue
wires and their connectors.
7 Unplug the connectors of the three
white and blue wires.
8 Slide out the fader assembly
completely.
9 The channel faders are mounted in
pairs. Remove the four screws for each
pair of faders (1 and 2) or (3 and 4).
0 The magnetic crossfader may be
removed by the two screws at each end
of the crossfader.
Reverse this procedure to re-assemble.
• Plug in all three cables before installing
screws.
• Confirm cables are not crossed, with
faders 1 & 2 on the left connector, faders
3 & 4 on the right connector, and the
blue crossfader wires in the center.
• Test all the faders before installing the
fader panel face plate and fader knobs.
RANE SIXTY-EIGHT MIXER FOR SERATO SCRATCH LIVE • OPERATOR'S MANUAL 2.4.4
4
7
1
2
3
6
8
5
9
0
55