HP Configuring Arrays Reference Manual page 57

Keyword
licensekey
logicaldrive
mnpdelay
*The CLI also uses this keyword and abbreviation for the terms box name and RAID array ID.
The show command
The show command enables you to obtain information about a device.
Syntax:
<target> show [detail]|[status]
When you specify a target that consists of several devices, the information in the output is normally less
comprehensive than when you specify only one device as the target. You can use the [detail] parameter
in this case to retain all the information usually given for individual devices.
An extra parameter is available for controller targets: config. This parameter is used as follows:
<target controller> show config [detail]
If you use the config parameter, the output includes information about each device connected to the
controller.
Example 1
=> ctrl slot=9 show
A typical output would be:
Smart Array P421 in Slot 9
Bus Interface: PCI
Slot: 9
Serial Number: PBKTV0XTAZZ005
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: A
Firmware Version: 0.02-106
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 15 secs
Cache Board Present: True
Cache Status: OK
Keyword
Abbreviation in ACU
CLI
lk tapedrive
ld waitforcacheroom
mnpd —
Abbreviation in
ACU CLI
td
wfcr
—
HP Array Configuration Utility 57