Table of Contents
Advertisement
Installation
1.
Apply marine grade grease to the
propeller shaft.
2.
Install the thrust washer with the
grooved side toward the gear case.
3.
Install the propeller.
4.
Install the washer with as shown.
5.
Lightly tighten the castle nut by
hand or wrench until the propeller
has no free play.
6.
Tighten the castle nut using a
torque wrench.
CASTLE NUT TIGHTENING
TORQUE:
0.7 lbf·ft (1 N·m, 0.1 kgf·m)
7.
Then, using a torque wrench,
tighten the castle nut until the first
available groove in the castle nut
aligns with the cotter pin hole. Do
not tighten past the first alignment
of the castle nut groove and the
SERVICING YOUR OUTBOARD MOTOR
cotter pin hole.
TIGHTENING TORQUE LIMIT:
33 lbf·ft (44 N·m , 4.5 kgf·m)
Do not tighten the castle nut above
the TIGHTENING TORQUE LIMIT,
or the propeller and shaf t may be
damaged.
MARINE GREASE
THRUST WASHER
8.
Be sure to replace the cotter pin
with a new one.
Use a Honda Genuine stainless
steel cotter pin or equivalent
cotter pin and bend the pin ends
as shown.
Note that these wrenches are not
included with the tool set that comes
with the outboard motor. Contact
your authorized Honda Marine dealer
for additional tool information.
PROPELLER
WASHER
CASTLE NUT
COTTER PIN
(stainless)
83
Advertisement
Table of Contents
