SERVICING YOUR OUTBOARD MOTOR
Install the oil drain bolt cover.
Push the lever of the oil drain bolt
cover in the direction pointed by
the arrow mark of ''LOCK'', and
install the oil drain bolt cover so
that the locking lug securely sets
on the projection of the under
With the outboard motor in a
vertical position, fill to the upper
limit mark on the dipstick (p.
with the recommended oil.
Engine oil refill capacity:
Without oil filter change:
6.9 US qt (6.5 L)
With oil filter change:
7.1 US qt (6.7 L)
Install the oil filler cap and tighten
Install and lock the engine cover.
Oil Filter Change
Drain the engine oil, and then
reinstall the drain bolt and sealing
washer. Reinstall the drain bolt
cover (see Engine Oil Change
Tilt the outboard motor, and place
a suitable container below the oil
drain guide to catch the used oil.
Use a suitable tool to remove the
oil filter, and thoroughly drain the
filter into the used oil container.
FILTER WRENCH, 65 mm
OIL DRAIN GUIDE