Entering Commands; Getting Help - Qlogic SANbox 3810 Interface Manual

Command Line Interface Usage

Entering Commands

Entering Commands
The command-line completion feature makes entering and repeating commands
easier.
Keystroke
Tab
Up Arrow
Down Arrow
Control-A
Control-E
Control-U

Getting Help

To display help for a command, enter the
command you are inquiring about. The following is an example of the help that is
available for the
SANbox #> help config edit
config edit [CONFIG_NAME]
This command initiates a configuration session and places the current session
into config edit mode.
If CONFIG_NAME is given and it exists, it gets edited; otherwise, it gets
created.
Admin mode is required for this command.
Usage: config edit [CONFIG_NAME]
1-4
Table 1-1 describes the command-line completion keystrokes.
Table 1-1. Command-Line Completion
Completes the command line. Enter at least one character and press
the tab key to complete the command line. If more than one possibility
exists, press the Tab key again to display all possibilities.
Scrolls backward through the list of previously entered commands.
Scrolls forward through the list of previously entered commands.
Moves the cursor to the beginning of the command line
Moves the cursor to the end of the command line.
Clears the command line.
Config Edit command.
If it is not given, the currently active configuration is edited.
Effect
Help command followed by the
S
59270-00 A