LVPS assembly removal
See
"LVPS assembly" on page 7-31
Note: Set the voltage range switch to the proper power setting for the geographic area you are in.
1.
Remove the fuser drive assembly. See
2.
Remove the rear cover. See
3.
Disconnect the J17 and J18 cables from the system board.
4.
Remove the four LVPS screws (A) type
5.
Remove the right rear cover screw (B) type
for the part number.
"Fuser drive assembly removal" on page
"Rear cover removal" on page
"121" on page 4-2
"121" on page
4-46.
4-22.
from the rear of the printer.
4-2.
Repair information
5061
4-53