Zenith SY3588 Operating Manual & Warranty page 13

STANDARD TV/SOURCE CONNECTIONS
SETUP 4:" TV WITH VCR AND CABLE BOX
I1:you receive 5'our television signal through your Cable Box and
VCR, connect your television as shown here.
DO NOT UNPLUG YOUR CABLE
BOX POWER CORD AT ANY TIME!
DO NOT PLUG YOUR TV POWER CORD
INTO THE BACK OF YOUR CABLE BOX!
;able Leading from.. Connected to..
Wall Jack--- TV--
'5 ohm Antenna From Antenna or "Antenna/Cable
7able Cable Service. 2."
TV-- Cable Box--
'5 ohm Anterma "Loop Out to "In."
".able Decoder."
Cable Box-- VCR--
'5 ohm Antenna "Out." "VHF In."
_able
) VCR-- TV--
'5 ohm Antenna "Out To TV." "Antenna/Cable
.'able 1."
VCR-- TV--
_udio/Video "R-Audio-L/Video "Video 1 or 2 In."
2ables Out."
(Supplied) TV-- VCR/Cable Box--
remote Emitler "StarSight Control Front Panels.
:able Port."
Notes: Use the Audio/Video connections if you wish to hear
Stereo sound from your VCR in tape playback mode.
StarSight Note: Do not adhere the Remote Emitters until af-
ter you have completed activating StarSight and you have
confirmed the correct codes that operate your equipment.
Once the codes are confirmed, peel off the backing of the
sticker on the Fmitters and adhere it in place.
a,
I1!you want to activate StarSight, proceed to the StarSight sec-
tion of the operating guide.
_=::::O::::= I ,
kL"-..
CABLE
// BOX
/ _'_-__ VCR
IIII _ _ _--_-_ _, FRONT
Cable Box and VC R Connection
Notes to abow;:
Your VCR Input jack may be ca;led;
VHF, VHF In, Ant In, RF In, UHF/VHF/CABLE IN, In from
Ant, Antenna In, From Antenna.
Your VCR Output jack may be called;
Out To TV, VHF Out, Ant Out, RF Out.
Your Cable Box Input and O_',tp,_tjacks may be called;
Cable In, Cable Out, Out to q-V, CATV In, CATV Out.
Note: Cables shown above can be purchased at your local Ze-
nith dealer. Measure each cable length needed.
_ivate StarSight.
3(_3-o 1 -- 5