Fluke 434/435
Users Manual
Display Contrast
Use submenu SETUP USER PREF as a starting point. How to get there is explained
above under Menu Navigation:
Reset to Factory Defaults
Proceed as follows to reset the Analyzer to factory default settings. Bear in mind that
recorded data and adjustments will be lost.
Use submenu SETUP USER PREF as a starting point. How to get there is explained
above under Menu Navigation:
Proceed as follows to reset the Analyzer to factory default settings without loss of data:
turn power off, then press and hold SAVE SCREEN and turn on again. You should hear a
double beep.
4-4
Highlight baudrate:
Adjust the required transmission speed.
Highlight the Printer type you want to use:
Press to confirm the selection.
ENTER
Press to return to the next higher menu SETUP USER
F5
PREF. This menu is the starting point for many adjustments
such as Display Contrast Adjustment and Reset to Factory
Defaults.
Adjust the Display Contrast to your personal taste.
Press to start the reset to default settings. Because of the risk
F1
of unwanted erasure of data, a confirm menu pops up.
Press to confirm the reset.
F5
.
.