Troubleshooting - Fluke 434 User Manual

Optional Accessories.
Logger Functions for Fluke 434 (Mains Signaling, Logging).
Optical Isolated RS-232 Cable
GPS Synchronization Unit
Print Adapter for Parallel Printers
Optical Isolated Trigger Probe (to test energy meters)
AC Current Clamp 200 A (10 mV/A) and 20 A (100 mV/A) switcheable.
AC Current Clamp 2000 A (1 mV/A) and 200 A (10 mV/A) switcheable, flexible.
AC Current Clamp 1000 A (1 mV/A), 100 A (10 mV/A), and 10 A (100 mV/A)
switcheable.
AC Current Clamp 3000 A (0.1 mV/A), 300 A (1 mV/A), and 30 A (10 mV/A)
switcheable.
AC/DC Current Clamp 100 A (10 mV/A) and 10 A (100 mV/A) switcheable.
AC Current Clamp 5 A (400 mV/A, 3 pack)
Service Manual (English)
(*): The SETUP/Clamp menu offers you a dedicated position to adapt the Analyzer for
use with i5s.

Troubleshooting

Analyzer does not start up.
The battery may be completely empty. In this case the Analyzer will not start up, even if
it is powered by the Battery Charger/Power Adapter. Charge the battery first: power the
Analyzer with the Battery Charger without turning it on. Wait about 15 minutes and try
turning on the Analyzer again.
Analyzer shuts down after a few seconds.
The battery may be empty. Check the battery symbol in the screen header. The
symbol indicates that the battery is empty and must be charged.
Attention: the Analyzer switches off automatically when powered by battery only if no
further knobs are operated after power-on (i.e. when the welcome screen is displayed).
Item
Tips and Maintenance
Troubleshooting
Ordering Code
Fluke-434/Log
PM9080
GPS430
PAC91
ITP120
i200s
i2000flex
i1000s
i3000s
80i-110s
i5s PQ3 (*)
www.fluke.com
22
22-3