Rebuild Mode - Fantec MR-35US3R Manual

3. RAID3 MODE
Switch to RAID 3 and press SET button. After a few seconds, the computer will
automatically capture an USB device. Then open computer management in order
to initialize and format the HDD. At this point all information will be deleted. During
formatting the HDD, the MR-35US3R HDD LED glitter with purple light. When the
LED send blue light, the format procedure is finished and the RAID 3 mode is
ready to use. In order to initialize, partition and format the HDD, refer to pint 2.5 of
this manual.
4. RAID5 MODE
Switch to RAID 5 and press SET button. After a few seconds, the computer will
automatically capture an USB device. Then open computer management in order
to initialize and format the HDD. At this point all information will be deleted. During
formatting the HDD, the MR-35US3R HDD LED glitter with purple light. When the
LED send blue light, the format procedure is finished and the RAID 5 mode is
ready to use. In order to initialize, partition and format the HDD, refer to pint 2.5 of
this manual.
5. BIG (COMBINE) MODE
Switch to BIG Combine mode and press SET button. After a few seconds, the
computer will automatically capture an USB device. Then open computer
management in order to initialize and format the HDD. At this point all information
will be deleted. During formatting the HDD, the MR-35US3R HDD LED glitter with
purple light. When the LED send blue light, the format procedure is finished and
the BIG mode is ready to use. In order to initialize, partition and format the HDD,
refer to pint 2.5 of this manual.

2.4 Rebuild Mode

If in RAID MODE 1, 3, 5 and 10 a HDD is damaged and replaced by a new one,
the MR-35US3R will automatically start the rebuild. You can identify a damaged
HDD by a permanent red glittering of the depending HDD LED and a warning
noise of the device. After you have inserted a new HDD, you can follow the
rebuild procedure of the MR-35US3R by a blue & red glitter of the HDD LEDs.
Next to the rebuild you can go ahead working on the unit and the data transfer is
indicated by a purple glitter of the HDD LEDs. When the LED sends blue light, it
means that the RAID rebuild has been finished.
()
()
()