Raid Mode Settings - Fantec MR-35US3R Manual

2.3 RAID MODE settings

()
CLEAR RAID or JBOD Mode
At first set the MODE switch to Clear MODE. Then keep the SET button pressed
and press the power switch. The HDD LED will glitter in turn blue & red while it
carries on the self-checking. During data transfer the HDD LED glitters in purple
light .When the LED sends blue light, it means that the RAID has been cleared. At
this point you can set up you preferred RAID MODE. If you like, you can use the
CLEAR RAID settings as JBOD mode, too.
()
1. SET RAID0 MODE
Switch to RAID 0 and press SET button. After a few seconds, the computer will
automatically capture an USB device. Then open computer management in order
to initialize and format the HDD. At this point all information will be deleted. During
formatting the HDD, the MR-35US3R HDD LED glitter with purple light. When the
LED send blue light, the format procedure is finished and the RAID 0 mode is
ready to use. In order to initialize, partition and format the HDD, refer to pint 2.5 of
this manual.
()
2. RAID1/10 MODE
Switch to RAID 1/10 and press SET button. After a few seconds, the computer
will automatically capture an USB device. Then open computer management in
order to initialize and format the HDD. At this point all information will be deleted.
During formatting the HDD, the MR-35US3R HDD LED glitter with purple light.
When the LED send blue light, the format procedure is finished and the RAID 1/10
mode is ready to use. In order to initialize, partition and format the HDD, refer to
pint 2.5 of this manual.