Whirlpool ACQ058PP0 Use & Care Manual page 9

• Auto - Cools room while it automatically controls fan
speed. You cannot change the fan speed, but you can
adjust the temperature by pressing the plus or minus
TEMP button.
F_ _"[E0 Lo.O
Temperature
• Press the plus TEMP button to raise the temperature 1° until it
reaches 86°F (30°C).
• Press the minus TEMP button to lower the temperature 1°
until it reaches 64°F (18°C).
Timer Delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off
(the
air condi'doner must be
On):
1. Press TIMER. Indicator light will flash.
O
2. Press the plus or minus TEMP button to change the delay
time from 1 to 24 hours.
3. Press TIMER again or wait 10 seconds. Indicator light will
remain on,
To set the -timer to tum on the air conditioner, keeping
previous
seffings:
1. Turn off air conditioner.
2. Press TIMER. Indicator light will flash.
3. Press the plus or minus TEMP button to change delay time
(1 to 24 hours).
4. press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, changing
the
previous seffings:
1. Turn air conditioner on.
2. Adjust MODE to Cool, Fan Only, or Power Saver.
3. Adjust FAN SPEED to Turbo, High or Low, or press Auto.
4. Adjust temperature between 64°F (18°C) and 86°F (30°C).
5. Turn off air conditioner.
6. Press TIMER. Indicator light will flash.
7. Press the plus or minus TEMP button to change delay time
(1 to 24 hours).
8. press TIMER again or wait 10 seconds. Indicstor light will
remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Indicator light will shut off.
To see the
remaining time (in hours):
1. Press TIMER once after it has been programmed.
2. While the display is showing the remaining time, you can
press the plus or minus TEMP button to increase or decrease
the time.
To operate air conditioner with remote control
NOTE: Two AAA batteries (not included) power the remote
control. Replace batteries after 6 months of use, or when the
remote control'starts to lose power. Be sure to install batteries
with correct polarity. Screwdriver required to remove battery
coven
To turn the air conditioner on or off:.
Press POWER.
To select the mode:
PressCOOL, FAN,or POWER SAVER.
• Fan - fan speed is sat to Turboonly.
• Cool or Power Saver- fan speed can be adjusted.
To select the fan speed (Cool or Power Saver mode only):
Press FAN SPEED for Turbo, High or Low or press AUTO.
zigX