Dealer Maintenance - Trane TUH2 User's Information Manual

The following warning complies with State of California law, Proposition 65.
User's Information
THIS PRODUCT CONTAINS FIBERGLASS WOOL INSULATION!
Fiberglass dust and ceramic fibers are believed by the State of California to cause cancer through inhalation.
Glasswool fibers may also cause respiratory, skin, or eye irritation.
PRECAUTIONARY MEASURES
• Avoid breathing fiberglass dust.
• Use a NIOSH approved dust/mist respirator.
• Avoid contact with the skin or eyes. Wear long-sleeved,
loose-fitting clothing, gloves, and eye protection.
• Wash clothes separately from other clothing: rinse
washer thoroughly.
• Operations such as sawing, blowing, tear-out, and
spraying may generate fiber concentrations requiring
additional respiratory protection. Use the appropriate
NIOSH approved respirator in these situations.
FIRST AID MEASURES
Eye Contact - Flush eyes with water to remove dust.
If symptoms persist, seek medical
attention.
Skin Contact - Wash affected areas gently with soap
and warm water after handling.
Regular Dealer Maintenance
Regular maintenace to be performed by a qualified ser-
vice professional ONLY.
The following warning complies with State of California law, Proposition 65.
HAZARDOUS GASES!
EXPOSURETO FUEL SUBSTANCES OR BY-PRODUCTS
OFINCOMPLETE FUEL COMBUSTIONIS BELIEVED BY
THE STATE OF CALIFORNIATO CAUSE CANCER, BIRTH
DEFECTS_OR OTHER REPRODUCTIVE HARM.
HAZARDOUS GASES
UNIT IS EQUIPPED WITH A BLOWER DOOR SWITCH
WHICH CUTS POWER TO BLOWER AND GAS VALVE
CAUSING SHUTDOWN WHEN DOOR IS REMOVED.
UNIT MUST NOT BE ALTERED TO ALLOW OPERATION
WITH THE BLOWER DOOR REMOVED. OPERATION
WITH DOORS REMOVED OR AJAR CAN PERMIT THE
ESCAPE OF DANGEROUS FUMES. ALL PANELS
MUST BE SECURELY CLOSED AT ALL TIMES FOR
SAFE OPERATION OF THE FURNACE.
ELECTRIC SHOCK HAZARD
IN THE EVENT THAT ELECTRICAL, FUEL OR ME-
CHANICAL FAILURES OCCUR, THE OWNER SHOULD
IMMEDIATELY TURN OFF THE GAS SUPPLY AT THE
MANUAL GAS VALVE LOCATED IN THE BURNER COM-
PARTMENT AND ELECTRICAL POWER TO THE FUR-
NACE AND CONTACT SERVICER.
FAILURE TO FOLLOW THIS WARNING COULD RESULT
IN PROPERTY DAMAGE, PERSONAL INJURY OR
DEATH.
Do NOT touch igniter. It is extremely hot.
32-5035-05
EXPLOSION HAZARD
SHOULD OVERHEATING OCCUR, OR THE GAS SUP-
PLY FAIL TO SHUT OFF, SHUT OFF THE MANUAL GAS
VALVE TO THE FURNACE BEFORE SHUTTING OFF
THE ELECTRICAL SUPPLY.
FAILURE TO FOLLOW THIS WARNING COULD RESULT
IN PROPERTY DAMAGE, PERSONAL INJURY OR
DEATH.
1. GENERAL INSPECTION - Examine the furnace
installation for the following items:
a. All flue product carrying areas external to the
furnace (i.e. chimney, vent connector) are clear
and free of obstruction.
b. The vent connector is in place, slopes upward
and is physically sound without holes or exces-
sive corrosion.
c. The return air duct connection(s) is physically
sound, is sealed to the furnace and terminates
outside the space containing the furnace.
d. The physical support of the furnace should be
sound without sagging, cracks, gaps, etc.,
around the base so as to provide a seal between
the support and the base.
e. There are no obvious signs of deterioration of
the furnace.
2. BLOWERS - The blower size and speed deter-
mine the air volume delivered by the furnace. The
blower motor bearings are factory lubricated and
under normal operating conditions usually do not
require servicing. Annual cleaning of the blower
wheel and housing is recommended for maximum
air output, and this must be performed only by a
qualified servicer or service agency.