To Remove And Replace Oven Door - Tappan TGF324BHDB Owner's Manual

General Cleaning
:ontinued)
The door is heavy. For1
safe, temporary storage, lay the door|
flat with the inside of the door facing/
down. /
To Remove and Replace Oven Door
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges A
3.
4.
(one on each side.)
Close the door to the quarter-open position. Grasp the door firmly on both
sides and lift up and offthe hinges.
To clean oven door, follow the instructions provided in the cleaning chart
under General Cleaning
Uff €lo_ straight off 2 door hin_s
General Cleaning
Figure 1
Figure 2
To Replace Oven Door:
1. Be surethe hinge arms are in the quarter-open position. Be careful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4. If the door is not in line with the oven frame, remove it and repeat the above
steps.
To Remove and
Replace
Oven Bottom
To Remove Oven Bottom:
1. Remove the oven racks.
2. Remove the two hold-down screws (Figure 1) at the rear of the oven
bottom panel. If the screws are too tight to remove by hand, use a
screwdriver.
3. To lift out the bottom panel, place fingers in the slots in the bottom. Lift
the rear of the panel up and back until it is clear of the lip at the front of
the panel (Figure 2).
4. Lift the bottom up and out.
To Replace the Oven Bottom:
1. Place the oven bottom in the oven with the back raised about 6= or until
you can insert the front of the oven bottom under the hold-down lip at the
front of the panel.
2. Push the back of the oven bottom down fully into place on the metal
flanges and insert the hold-down screws.
13