Button Assignments - Sony HT-DDW700 Operating Instructions Manual

Changingbutton
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the DVD jacks on the receiver, you
can set the DVD button on this remote to
control the DVD recorder.
2
Hold down the input button of
which you want to change the
assignment.
Example: Press DVD.
Referring to the table below,
press the corresponding button
for the category you want.
Example: Press 4.
Now you can use the DVD button to
control the DVD recorder.
Categories and the
corresponding buttons
Categories Press
VCR (command mode VTR 3) a) l
VCR (command mode VTR 2) a) 2
DVD player/DVD recorder 3
(command mode DVD 1)b)
DVD recorder 4
(command mode DVD3) b)
CD player 5
MD deck 6
Tape deck B 7
Tuner (this receiver) 8
DVR (Digital CATV terminal) 9
DSS (Digital Satellite Receiver) 0/10
a/Sony VCRs are operated with a VTR 2 or VTR 3
setting which correspond to 8 mm and VHS
respectively.
b)Sony DVD recorders are operated with a DVD 1 or
DVD 3 suiting. For details, refer to the operating
instructions supplied with the DVD recorders.
To clear all remote button
assignments
Press I/_, AUTO CAL and MASTER VOL
at the same time.
The remote is reset to its factory settings.
r-
NI
q)
3
09.
49us