Using The Remote; Changing Button Assignments - Sony HT-DDW8500 Operating Instructions Manual

Using the Remote

Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO 1 jacks on the receiver,
you can set the VIDEO 1 button on this remote
to control the DVD recorder.
Note
You cannot change the settings of DMPORT and
TUNER buttons.
1
Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO 1.
2
Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 4.
Now you can use the VIDEO 1 button to
control the DVD recorder.
Categories and the
corresponding buttons
Categories
VCR (command mode
a)
VTR 3)
VCR (command mode
a)
VTR 2)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
Euro Digital Satellite
Receiver
DVR (Digital CATV
terminal)
DSS (Digital Satellite
Receiver)
Blu-ray disc player
(command mode BD1)
Blu-ray disc recorder
(command mode BD3)
TV
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which corresponds to 8 mm and VHS
respectively.
b)
Sony DVD recorders are operated with a DVD1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders.
c)
For details on the BD1 or BD3 setting, refer to the
operating instructions supplied with the Blu-ray
disc player or Blu-ray disc recorder.
To clear all remote button
assignments
While holding down MASTER VOL –, press
?/1 and DMPORT.
The remote is reset to its factory settings.
Press
1
2
3
b)
4
b)
5
6
7
8
9
c)
0/10
c)
/>10/CLEAR
z
(RM-AAU021
only)
-/--/>10/CLEAR
(RM-AAU023
only)
75 GB