Specifications - Sony HT-DDW700 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing tile receiver's memory may remedy
the proNem (page 19). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear See
All memorized settings page 19
Customized sound fields page 42
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(Models of area code U only)
With 6 ohm loads, both channels dri_,en, from
120 20,000 Hz; rated 85 watts per channel
nlinimum RMS power, with no more than
0.7% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Po,a er Output ])
Models of area code U
(6 ohms I kHz, THD 10%)
FRONT2): 133 W/ch
CENTER2): 133 W
SUR2): 133 W/ch
(6 ohms 100 Hz, THD 10%)
SUB WOOFER2): 135 W
Models of area code CA
(6 ohms I kHz, THD 0.7%)
FRONT2): 85 W/oh
CENTER2): 85 W
SUR2): 85 W/ch
(6 ohms 100 Hz, THD 0.7%)
SUB WOOFER2): 85 W
(6 ohms I kHz, THD 10(7_)
FRONT2): 133 W/ch
CENTER2): 133 W
SUR2): 133 W/ch
(6 ohms I00 Hz, THD 1()(7_ )
SUB WOOFER2): 135 W
1) Measured under the following conditions:
Area code Power requirements
U, CA 120 V AC, 60 Hz
2) Depending on the sound field setlings and Ihe
source, there may be no SOlllld outpul.
n.
"8
continued_
55us